15/22
45
Zooming Fine
000-255
Linear Zooming in 16 bit precision
28 31
46
Pan
000-255
Pan(0°~540°)
32
47
Pan Fine
000-255
Pan in 16 bit precision
29 33
48
Tilt
000-255
Tilt(0°~270°)
34
49
Tilt Fine
000-255
Tilt in 16 bit precision
35
50 Pan & Tilt Speeds
000-255
Pan & Tilt Speed from Fast to Slow
30 36
51
Control
000-047
Reserved
048-080
Reset
081-112
Reserved
113-144
Lamp Off ( Delay for 3 s)
145-168
Reserved
169-200
Lamp Half Power
201-223
Reserved
224-255
Lamp Full Power
Remark:
If you intend to turn on/off the lamp via the last channel of the controller, don’t attempt to push the channel to value
224-255 immediately after turning it off, or push the slide bar to value 224-255 to wait it cooling. Under these 2
circumstances, the lamp can not be turned on. The right operation is: turn it off---cool down---push the slide bar to turn it
on.
LED INDICATION
Green
On
DMX signal OK
Off
No DMX signal
Flash DMX
signal
error
Yellow
On
Setting the panel
Blue On
Power
Red/Green
Red
Running self test mode
Green Reserved
Green
On
Wireless signal OK
Off
No connection to any transmitter
Flash
Lost contact with the transmitter or linking transmitter
MAINTENANCE
If the projector’s lens becomes damaged or broken it should be replaced. If the lamp becomes damaged or deformed in any way it
must be replaced. If the light from the lamp appears dim this would normally indicate that it is reaching the end of its life and it should
be changed at once, aged lamps run to the extremity of their life might explode. If the projector does not function, check the fuses on
the power socket of the projector, they should only be replaced by fuses of the same specification. The projector has overheat
protection device that will switch off the projector in case of overheating. Should it happen, check if the fans are blocked or not, or if
they are dirty, clean them before switching on the projector again.
Any maintenance work should only be carried out by qualified technicians.
LUBRICATION
To ensure the smooth rotation of the rotating gobos and movement of the lens for focusing, it is recommended that the bearings for
the rotating gobos and the 2 sliding tracks for the focusing lens holder be lubricated every two months. Use only high quality,
high-temperature grease .
