7/18
STAND-ALONE MODE
To operate the projector without connecting a controller, setup options master mode disabled, the projector
will run in Stand-Alone mode automatically.
MASTER/SLAVE MODE
Without using a controller, many projectors can run synchronously in the Master/Slave mode by linking them
with each other. Select one projector as the master with setting options master mode enabled but slaves.
Regard the other projectors as the slaves with setting options slave mode enabled and all DMX start
address “001”.
Connect the controller’s output to the first fixture’s input, and connect the first fixture’s output to the second fixture’s input
and connect the rest fixtures in the same way. Eventually connect the last fixture’s output to a DMX terminator as shown
in the figure below.
DMX IN
DMX OUT
TERMINATER
DMX IN
DMX OUT
DMX IN
DMX OUT
MASTER
SLAVE
SLAVE
LED INDICATION
On
DMX signal OK
Off
No DMX signal
Green
Flash
DMX signal error
Yellow On
Setting the panel
Blue On
Power
Red
Running Slave mode or self test mode
Red/Green
Green
Running Master mode
