4/18
INSTALL THE PROJECTOR
2PCS
2PCS
Front cover
Front cover
Power supply
Handle
Control panel
Clamp
Safety cord
Power switch
DMX connection
Lock screw for tilt
Safety cord connection
The unit was designed to make installation easy: it can be fitted on a floor or ceiling as required.
Take mounting board and 2 safety cords out from the package and mount the mounting board on the underside of fixture
with 6 screws. Then mount 2 clamps on the underside of mounting board with 4 retainers. Hang the fixture on the
structure and fasten the screws attached to each clamp.
WARNING:
To pass 2 SAFETY CORDS through 2 HOLES
for safety!
Always ensure that the projector is firmly anchored to avoid vibration and slipping whilst functioning. Always
ensure that the structure that you are going to mount the projector is secure and is strong enough to support a weight of
MEGA COLOUR 2000.
WARNING:
1. Unlock the PAN and TILT before the 1
st
application of projector for safety.
2. The projector MUST be lifted or carried by the HANDLES instead of clamps.
3. For safety the safety cord should afford 10 times of the unit’s weight.
FITTING THE LAMP
M10 nut
Front cover
Lamp
Protection plate
for lamp
Fan group
Back cover
M10 nut
Lock the tilt before changing the lamp.
Remove the front cover and back cover by undoing the 16 lock catches and 8xM4 screws.
Undo fan group by undoing 6 screws.
Remove the protection plate of lamp by undoing the 3xM4 screws.
Do not change new lamp until old lamp has cooled.
Undo the 2xM10 screws from double ends of the lamp and then pull out the old lamp toward lamp cap.
Insert the new lamp in the lamp-holder, and ensure the little bubble on the lamp is at a right angle (90°) to the beam path.
Keep the lamp clean during installation.
Reinstall all the components before removing by retighten the screws.
