PR Lighting AQUA 350 BEAM PR-2368, Manual

Page: 4 / 26

4/26
●
There are safety cord holes at the bottom of the base of a projector. In view of safety, please run the safety
cord supplied through the safety cord holes for safety support.
●
Before any installation, maintenance and cleaning work, please ensure the projector is disconnected from
power mains.
●
After running for 5minutes, the temperature of the housing of the projector is 35
℃
.After stable operation ,
its temperature is
55
℃
.
●
While the lamp is stricken for the first time, there will be smoke and strange smell. It’s normal and does not
mean the projector has some defects.
●
Don’t touch the covers of the working projector(They are very hot!)
●
Do not mount the projector directly on inflammable surface.
●
Do not project the beam straightly on combustible items and the minimum distance between the
projector and illuminated items is 10m.
●
A projector should be installed with good ventilation and the minimum distance between the projector
and walls is 50cm. At the same time, please ensure the fans and air inlets and outlets are workable.
2. INSTRUCTIONS
●
CLEANING AND MAINTENANCE
If a projector can’t start. Please check if the fuse is blown up. If it does, replace it with a new fuse with same ratings. And the
projector has over-temperature protective device. If the temperature is too high, the protective device will be triggered to shut the
projector off. When it happens, please check if the fans run normally or fan shield is blocked by dust. After the issue is solved,
restart the projector.
The accumulation of oil, smoke and dust on the front lens will compromise the light output. Cleaning a projector is very
necessary to ensure a reliable use of it. Cooling fans need to be cleaned every 15days.
Cleaning frequency is to be decided by operations and its environment. Use soft cloth and normal detergent for glass for cleaning
work. It’s advised external optical system be cleaned every 20days. Keep front lens clean and do not touch it with bare hands.
Special Reminder:
It’s a normal phenomenon to see any slight vapour on the surface of the front glass, during the using of the outdoor waterproof
unit.
●
Before any maintenance and cleaning, please ensure the project is off the power
●
Only qualified person is allowed to do maintenance
●
During maintenance and before maintenance, the projector must be off power.
●
To avoid internal damage, sun light or other light mustn’t penetrate into the projector via front lens
whether it runs or not
●
Do not use alcohol or other organic solvent to clean the housing to avoid damage.
●
Do not use any solvent with chemical elements to clean color filters or hot mirror.
●
LUBRICATION
To ensure smooth movement of gobos and focus lens, it’s advised rotators’ bearings and 2 sliding bars for focus lens be lubricated
every 2 months. High quality and high temperature lubricant/grease is advised..