PR Lighting AQUA 350 BEAM PR-2368, Manual

Page: 10 / 26

10/26
●
STAND-ALONE MODE
Operate the projector without connecting with a controller, enable the master mode through the operation panel, the
projector will run in Stand-Alone mode automatically.
DMX address can be set at any number within 512
.
●
MASTER/SLAVE MODE
Many projectors can run synchronously in the Master/Slave mode by linking them with each other. First,
connect the first fixture’s DMX output to the second fixture’s DMX input using XLR-XLR control cable and then connect the second
fixture’s DMX output to the third fixture’s DMX input, and so on until all projector are connected in this way. Eventually connect the
last fixture’s DMX output to a DMX terminator. Set 1
st
projector as the master and others are Slaves.
Start Addresses of all Slaves are 001; Operation mode of the Master can be set any mode for a Master’ and Slaves’ operation mode can
be set accordingly.
After Powered on, the group will run in Master/Slave Mode
6. OPERATION MENU
1
st
level menu 2
nd
level menu 3
rd
level menu 4
th
level menu
DMX Address
1-494
Reset Are You Sure
Config Set
DMX Mode
（
Default
：
Standard
）
Standard 19
Short 15
LampControlSe
（
Default
：
By Control Chann
）
By Control Chann
By Power On
ByDmxPresent
Loss of DMX
（
Default
：
Normal Time Out
）
Normal Time Out
Hold Last Value
Wireless Mode
（
Default
：
XLR First
）
XLR First
XLR Only
DMX INPUT DMX OUTPUT
MASTER SLAVE SLAVE
DMX INPUT DMX OUTPUT DMX INPUT DMX TERMINATOR