PR electronic 4104, Product Manual

Page: 13 / 25

4104V102-UK 13
45xx display readout of input 4...20 mA loop error detection
and signal ”outside range”
Input loop error check:
Device: Configuration Input loop error detection
4104
OUT.ERR=NONE. OFF
OUT.ERR=DOWN, UP and ZERO ON
Input ”outside range” limits - readout (IN.LO, IN.HI):
Input Range Readout Limit
CURR All - unipolar and bipolar
IN.LO < -23 mA
IN.HI > 23 mA
VOLT All - unipolar and bipolar
IN.LO < -12 V
IN.HI > 12 V
Display readout below min. / above max. (-1999, 9999):
Input Range Readout Limit
All All
-1999 Display readout <-1999
9999 Display readout >9999
Input loop error detection - readout (LO.ER):
Input Range Readout Limit
CURR 4...20 mA LO.ER <= 3.6 mA; > = 21 mA
Readout at hardware error
Error search Readout Cause
Check measurement of analog output AO.ER No load on the current output (only S4...20 mA)*
Communications test between 45xx
and 4104
NO.CO Connection error
Hardware error FL.ER Error in FLASH**
Configuration error CO.ER Error in FLASH**
Check that saved configuration in 45xx
matches device
TY.ER Invalid type or rev. no.
Hardware error AO.SU Analog output supply error*
Hardware error RA.ER RAM error*
Hardware error EE.ER EEPROM error*
Hardware error AD.ER A/D converter error*
Hardware error IF.ER Flash check sum error*
!
All error indications in the display flash once per second. The help text explains the error. If the error is an
input loop error, the display backlight flashes as well - this is acknowledged (stopped) by pushing the
3
button.
*
Error is acknowledged by either stepping through the basic setup, or by resetting the device power.
Some types of errors can only be acknowledged by resetting the device power.
** Error is acknowledged by stepping through the basic setup.