12
13
Step 4:
Pre-align the automation to the gate, positioning the rack over the gear
and pushing the assembly against the gate. Then mark the fixing holes in the floor
or concrete base.
Step 5:
Drill for fastening by positioning the automator aligned to the gate. Before
tightening the S ¼ “x 2 ½” bolts, move the gate, making sure that it does not lean
against the automator during its course. If this occurs, pull back the automation.
Step 6:
With the automator unlocked, position the rack bar on the gear and aligned
with the gate.
It is necessary to leave approximately a clearance of 2 mm between the top of the
gear tooth and the bottom of the cog of the rack.
Step 7:
Secure the rack to the entire length of the door leaf with solder or screw
every 300 or 400 mm.
MARK THE FIXING
HOLES IN THE FLOOR
MARK THE FIXING
HOLES IN THE FLOOR
AuTOmATION
FIxING hOLES
INSERT 2 SCREWS
S 1/4” x 2 1/2” WITh
S10 ADApTER SLEEVE
INSERT 2 SCREWS
S 1/4” x 2 1/2” WITh
S10 ADApTER SLEEVE
CLEARANCE OF 2 MM
300 OR
400 mm
300 OR
400 mm
