page no. 10 of 16
PQ-A
Range Users, Installation & Servicing Instructions Doc Ref M308 issue 1.1 May 2019.
Warning:
Switch off/unplug the heater from
the mains supply when mounting or adjusting
the heater position.
• The heater must be mounted in such a way that the
halogen lamp does not slant more than 4° from the
horizontal, when viewed from the front.
• The heater is suitable for installation only on a normally
non-flammable surface. Observe the minimum safe
distance between the heater body and inflammable
surfaces when mounting.
• Refer to Section 1.2 for the recommended mounting
height for the heater.
• Keep out of the reach of children.
1. Separate the heater from the mounting bracket by
loosening the two nuts at the rear of the heater.
2. Securely fasten the bracket to the mounting surface
using the fixing holes in the bracket.
3. Replace the heater on the bracket using the nut and
bolt supplied and fix in the required angular position by
tightening the fixing bolt on the bracket. See diagram
below.
Warning: :
Switch off/unplug the heater from
the mains supply when mounting or adjusting
the heater position.
• The heater is suitable for installation on chains that are
suitably fixed to a structure sufficient to hold the weight of
the heater.
• Observe the minimum safe distance between the heater
body and inflammable surfaces when mounting.
• Refer to Section 1.2 for the recommended positioning
of the heater with regards to minimum distances.
• Do not install the heater in a corner! If installing near
a corner, always ensure minimum side wall distance is
adhered to.
• Always allow the heater to cool before attempting to
reposition/move. Never attempt to move the heater while
it is switched on!
1. When chain hung, ensure chains are of adequate size
and securely fixed to support the weight of the heater.
2. Fix the heater assembly to the chains via the holes in
the body brackets if intending to face directly down as
shown below. On units having channel brackets, attach the
chains to the adjustable brackets as shown below.
• Ensure the supply cord does not rest on the heater.
SE
E SEC
TI
O
N
1
.2
PLAN VIEW
SIDE VIEW
SE
E
SEC
TI
O
N
1
.2
