Powr-Flite 1978802, Manual, Page: 4 / 23

4
PS 400 5.959-067
Please read these operating instructions before
starting and strictly observe the “Safety
Instructions 5.956-250”.
Important battery information
- Please recharge the battery after each time the
unit has been used.
Only use battery charger which is recommend by
the manufacturer.
- If the battery has been discharged to a point where
the needle of the battery charge indicator has
dropped out of the green zone (see section 2,
“Operation”), it is mandatory to recharge the battery
for at least 14 hours.
- Strictly observe the information on handling
batteries supplied by the battery manufacturer.
- Battery acid should be always handled with extre-
me care (injuries and destruction of clothing).
- Use goggles and comply with all instructions and
regulations.
- Rinse away any acid which has splashed on skin
or clothing with large quantities of water.
- Never under any circumstances use a naked
flame, generate sparks, or smoke near a battery
or in a battery charging area. Explosion hazard.
- Do not place tools or similar objects on the battery.
Risk of short-circuit and explosion hazard.
Guarantee
- The guarantee terms published by our responsible
marketing company apply in each country. We
shall repair any fault in your appliance free of
charge within the period of guarantee if this is due
to defective materials or workmanship. When
making a claim under guarantee please contact
your dealer or your nearest authorized customer
service office with proof of purchase.
Maintenance work
Disconnect the battery terminal before
cleaning and maintaining the unit and
before replacing parts. Do not tilt the
unit as battery acid may run out.
Maintenance Schedule PS 400
Daily
1 Sweeping roller check for tape, rope, etc.
which may have become
caught
2 Dust filter check for damage
Every 40 operating hours
3 Battery,
low-maintenance check fluid level
4 Brushing lip and side
skirts check for damage
5 Belt check for damage
6 Sweeping roller Check for wear
Every 500 operating hours
7 Electric motor check carbon brushes for
signs of wear
Technical Data
Nominal voltage ....................................... 12 V
Nominal current .......................................
26 A
Output ...................................................... 250 W
Degree of protection ..............................
IP 24
Length x width x height .. 1200 x 770 x 925 mm
Weight ....................................................... 51 kg
Travelling and brushing speed ............... 4 km/h
Area capacity with side brush ........... 2800 m
2
/h
Volumetric air flow ................................. 43 l/s
Low air pressure ..................................
7 mbar
Brushing width with side brush ............ 710 mm
Brushing width without side brush ....... 470 mm
Dirt container capacity .......................... 25 (60) l
Filter area .................................................... 1 m
2
Sound pressure level (DIN 45 635) ..... 69 dB(A)
Application category ...................................
“U”
Permitted gradient ...................................... 15 %
Unit vibrations .................................... < 2.5 m/s²
Ambient conditions:
Temperature .................................. –5 to + 40 °C
Air humidity, not wet with dew ............... 0–90 %
+
ENGLISH