FB8X Service Manual Rev. C, 9/28/10 Page 49
S E R V I C E A N D C A L I B R A T I O N P R O C E D U R E S
6
6 . 6 S e n s o r s
6.6.1 Removing the Strip Present PCA
1. Remove the Right and Left Covers.
2. Remove the Front Cover.
3. Remove the four M4x10 PH PHIL Screws
attaching the Tamping Platform to the
Right and Left Side Plates (fig 1 & 2).
4. Disconnect the Wire Harness connector
from the Strip Sensor.
5. Remove the M3x6 PH PHIL Screw at-
taching the Strip Sensor bracket to the
Tamping Platform.
6. Remove the M3x6 LG PH PHIL Screw
attaching the Strip Sensor to the Bracket.
Installing the Strip Present PCA
1. Attach the Strip Sensor to the Strip
Sensor Bracket using one M3x6 LG PH
PHIL Screw.
2. Attach the Strip Sensor bracket to the
Tamping Platform using the M3x6 Screw.
3. Insert the Wire Harness connector
through the hole on the other side and
connect to the Strip Sensor (fig 3).
4. Reattach the Tamping Platform using the
four M4x10 Screws.
5. Reattach the Right and Left Covers.
6. Reattach the Front Cover.
Fig 1
Fig 2
Fig 3
After replacing the Strip Present PCA, perform the following tasks:
TASK 1
Recalibrate Strip Sensor in the CAL STRIP SENSOR menu.
TASK 2 Check Strip Sensor in the CHECK SENSORS menu.
TOOLS REQUIRED: #1 & #2 Phillips Screwdrivers