background image

Model No. ACD039

IMPORTANT ADVISORY NOTES

• 

The spotlight becomes very hot during use. DO NOT touch lens or block lens area during operation.

•   Light beam is  extremely  powerful.  DO NOT shine directly  into eyes.
•      Unit is not  waterproof.  DO NOT use Spotlight  under  water  or immerse in water.
•      Do not use with dry cell batteries. These batteries may burst and cause injury to person or damage 

 

 

personal property.

•   Do not attempt to face the battery being jumped. Stay away as far 
 

as possible from the battery when making the final connection.

• 

DO NOT CONNECT TO or jump start a 6 or 24 Volt battery. 

 

If battery acid comes in contact with skin or eyes, rinse immediately with water for 20 minutes. Seek 

 

 

medical attentionif redness, irritation or pain is present.

• 

DO NOT smoke, use matches, lighters  or  an  open  flame  near batteries.

• 

This product contains chemical substances including lead. Wash hands thoroughly after handling 

 

 

Lead Acid Batteries.

•   Never allow red (Positive) and black (Negative) clamps to   come in contact with each other or

 

 

contact with metal object at the same time.

• 

To protect  against  electrical  hazards,  do  not  immerse  charger, adapters or unit in water or other 

 

 

liquid.

•   Close supervision is necessary when working near children. 
•   Do not use unit for applications other than its intended uses. 
•   Always connect the red (+) clamp to the positive battery terminal first. Connect black (-) clamp to the 

 

 

vehicle engine block, or a metal part of the vehicle which is connected to the vehicle main ground 

 

 

system as final connection.

•   Jump start vehicles in a well-ventilated area only. 
•   Do not expose the unit to moisture or use it in exceptionally hot onditions.
•   Wear complete eye and clothing protection. Do not touch eyes while working near battery
• 

Do not attempt to remove or replace the battery used in thisdevice.  When the  battery  has  reached  

 

 

the  end  of  its  useful lifetime, take the entire unit to a battery recycling facility.

• 

Remove  metal  and  personal  jewelry  such  as:rings,    bracelets,  necklaces  and  watches,  while

 

 

working  with a lead acid battery. This can produce a short-circuit that may cause severe burns. 

 

 

Never charge or jump-start a frozen battery.

•   Do not  operate  this  device  while  wearing  vinyl  clothing.      
 

Static electricity may be generated when vinyl clothing is rubbed.

• 

This product is not intended for use in the rain or temperatures above 150ºF.

• 

Use only the provided chargers, cables and clamps. Unauthorized parts may damage  the  unit. 

 

This product has no consumer serviceable parts except the replaceable fuses. 

• 

Keep out of the reach of children. 

•   Keep battery terminals clean. Be careful to keep corrosion from coming in contact with eyes.
• 

Do not let the cords of the unit or jumper clamps get wet. 

Sheet 3 of 8

Summary of Contents for PowerBeam ACD039









Reviews: