2
ASSEMBLY
ASSEMBLY
2
UNPACKING
Refer to Figure 1
Check for shipping damage. Check immediately whether
all parts and accessories are included.
ITEM DESCRIPTION
QTY
A
Miter Saw Stand
1
B
Quick Release Mounting Brackets
2
C
Roller Bars
2
D
Axle
2
E
Wheels
2
F
Locking Nut M8 (wheels)
4
G
Washer Ø8 (wheels)
4
H
Washer Ø12 (wheels)
2
I
Handle
1
J
Screw M6 x 35 (handle)
2
K
Nut M6 (handle)
2
L
Miter Saw Mounting Hardware
(M8 x 45 mounting bolt, washer, lock
washers and nut)
4
A
B
F
C
H
G
I
K
L
J
Figure 1
D
E
WARNING
Do not use the miter saw stand until it is completely
assembled and you have read and understood this entire
operating manual and the operating manual of the tool
being used with this miter saw stand.
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs (150 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
TOOLS NEEDED
The following tools (not included) are needed to assemble
the miter saw stand:
Adjustable pliers
Phillips screwdriver
10 mm wrench or socket
13 mm wrench or socket
UNFOLD THE WORK LEGS
Refer to Figure 2
• Place the miter saw stand on a flat surface with the
folded legs facing up.
• Depress the release lever and rotate the leg until it
clicks and locks into the open position. Repeat for
each leg.
• The stand should be stable and should not rock.
Release
Lever
Figure 2
Release
Lever
• Place the miter saw stand in the upright position on a
flat surface.
ASSEMBLE WHEELS
Refer to Figure 3
• Slide the axle through the axle bracket, turn the axle
until the machined end fits into the inside bracket
hole. Place one small (Ø8) washer and nut onto axle.
Tighten nut.
NOTE:
The axle has a retaining ring on one end and is
machined to fit the axle bracket hole on the other end,
make sure the machined end is inserted into the axle
bracket first.
• Slide one larger (Ø12) washer and the wheel on the
axle. Secure in place with the small (Ø8) washer and
nut. Tighten nut.
NOTE:
Raised hub goes to the inside.
• Repeat with other wheel.
