3
ASSEMBLY
ASSEMBLY
3
Figure 3
Axle
Wheel
Nut
Washer
(Ø8)
Washer
(Ø8)
Nut
Washer
(Ø12)
Axle Bracket
Retaining
Ring
ASSEMBLE HANDLE
Refer to Figure 4
• Secure handle to frame with hardware supplied.
Figure 4
Screws
Nuts
ASSEMBLE ROLLER BARS
Refer to Figure 5
• Raise the locking lever and place the roller arms into
the roller bar supports, slide up and down to desired
location and lower locking lever to secure in place.
Figure 5
Roller Bar
Roller Arm
Locking
Lever
MOUNTING THE MITER SAW
Refer to Figure 6-7
WARNING
Risk of accidental starting and serious personal injury.
Unplug the miter saw before attaching it to the miter
saw stand.
WARNING
Do not mount a table saw on this miter saw stand.
Aggressive feeding of sheet materials into a table saw
could cause the stand to tip over.
NOTE:
This miter saws stand is to be used with miter
saws with four mounting holes in a rectangular pattern..
• Mount the miter saw to the quick-release mounting
brackets using the supplied hardware (mounting bolt,
washer, lock washers and nut) as shown.
NOTE:
Placing a 2 x 4 or spacer under one side of the
miter saw to raise the saw's mounting feet will make
assembly easier.
• After the saw is mounted to the quick release mounting
brackets make sure they are parallel to each other.
Make sure the release levers are oriented as shown in
Figure 6.
Figure 6
Bolt
Release
Lever
Lock Washer
Nut
Flat Washer
