6
M-Drive | SERVICE MANUAL
4. Discharging the Module’s Capacitors Bank:
5. Troubleshooting:
Checking the Output IGBTs
(Fig. 3)
Highlighted on (Fig. 3) are pins 1/2 and 19/20.
Connect one end of a
(Fig. 3)
With a Multimeter set to Ohm, check for any short circuit
in the Output IGBTs by probing the points highlighted on
(Fig. 4)
Insert the DSP Board in the SO1000 socket.
Connect the Interface to the DSP Board.
Proceed by connecting the
to the PL2 connector on the module and
replicate the connections on the portrayed External
Power Supply.
Slowly increase the output voltage on the power supply
to +12Vdc and -12Vdc (Fig. 5).
Check the absorption, fans and interface must be
disconnected:
Red +18Vdc: 40mA
Black -18 Vdc: 40mA
Green +12Vdc: 470mA ± 15%
Blue -12Vdc: 50mA ± 15%
The following page contains further testing procedures to
be completed with the use of an oscilloscope.
Zoom on the waveforms to check the shape of the
resulting waves.
Out Of Range Values, Blown IGBTs are signs of
malfunction in the AMP section, please order the
KT000852.R KIT M-DRIVE AMP 1CH
(Fig. 4)
Ω
Ω
(Fig. 5)
+18 V 40 mA
+12 V 470 mA
–18 V 40 mA
–12 V 55 mA
DSP Board interface connectors
Summary of Contents for M-Drive
Page 2: ...Intentionally left blank...
Page 23: ...Intentionally left blank...
