Powersmart PS76138A, Instruction Manual

Page: 14 / 21

14
OPERATING INSTRUCTION
Mounting the Extraction Adapter
Before any work on the power tool, remove the battery. Fasten the extraction adapter to the dust port
without tools.

The extraction adapter may not be mounted when no external dust extraction is connected.
Otherwise the extraction channel can become clogged.

Do not connect a dust bag to the extraction adapter.

Otherwise the extraction system can become clogged. To ensure optimum extraction, the extraction
adapter must be cleaned regularly.
Adjusting the Cutting Depth

Adjust the cutting depth to the thickness of the work-piece. Less than
a full tooth of the blade teeth should be visible below the workpiece.

Loosen wing bolt. For a smaller cutting depth, pull the machine from
the base plate; for a larger cutting depth, push the machine toward the
base plate.

Adjust the desired cutting depth at the cutting-depth scale.

Tighten wing bolt again. When setting the cutting depth, use the
reference mark to the side of the cutting-depth scale.
Adjusting the Cutting Angle
It is best to place the machine on the face side of the blade guard.

Loosen wing bolt.

Tilt the saw side-wards.

Adjust the desired setting at the scale.

Tighten wing bolt again.
Note: For bevel-cuts, the cutting depth is smaller than the setting indicated
on the cutting-depth scale.
Switching On and Off
To start the machine

First push the lock-off button for the On/Off switch.

Then press the On/Off switch and keep it pressed.

When cut the wood, put the machine on the workpiece and push it along the wood.
To switch off the machine

First take out of the machine from workpiece.

Then release the On/Off switch.
Note: For safety reasons, the On/Off switch cannot be locked; it must remain pressed during the entire
operation.
Fig.5
Fig.4