POWX07587
EN
Copyright © 2017 VARO NV
P a g e
|
21
www.varo.com
10.2.8
Auxiliary wood facing (Mitre gauge) (Fig. 60)
To prevent a long board from wobbling, fit the Mitre gauge with an auxiliary fence board.
Fasten with bolts/ nuts after drilling holes, but fasteners must not protrude from the face board.
10.2.9
Carrying tool (Fig. 61)
Make sure that the tool is unplugged. For the tool just used in the Mitre saw mode, secure the
blade at 0° bevel angle and the turn table at 0° Mitre angle. Lower the handle fully and lock it
in the lowered position by fully pushing in the stopper pin.
Carry the tool by holding the tool part shown in the figure. (Fig. 62)
CAUTION:
▪
Always secure all moving portions before carrying the tool.
▪
Before carrying the tool, always set up the tool in the Mitre saw mode.
▪
Make sure that the lower blade guard C is installed on the tool.
11 MAINTENANCE
CAUTION:
▪
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
WARNING: Always be sure that the blade is sharp and clean for the best
and safest performance.
11.1
Replacing carbon brushes (Fig. 64 & 65)
Remove and check the carbon brushes regularly. Replace when they wear down to the limit
mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes
should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to
remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
11.2
After use
▪
After use, wipe off chips and dust adhering to the tool with a cloth or the like to assure
maximum service life. Keep the blade guards clean according to the directions in the
previously covered section titled “Blade guard”. Lubricate the sliding portions with machine
oil to prevent rust.
▪
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by an Authorized Service Centers, always using original
replacement parts.
11.3
Service
Only qualified specialist personnel and original replacement parts should be used for repairs.
This will ensure that your device remains safe.
Damaged switches must be replaced by our after-sales service department.
If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by a
qualified person (qualified electrician).