44 www.powermaxfitness.net
Note that the running belt cannot be adjusted too tightly, which will break the running belt,
increase the pressure of the front/rear roller, and it will damage to the roller bearing.
Abnormal sounds or other problems. If you want to reduce the tension of the running belt,
please turn the wrench counterclockwise, paying attention to the same distance between
the left and right sides.
2.
Adjust the belt to the middle position
When you use the treadmill, the pressure on the two legs is not the same as the strength of the
running belt during running, which causes the running belt not in the middle position. This
phenomenon is normal. When no one is running on the running belt, it will return to the center.
You need to adjust the belt back to the middle position.
How to adjust the belt to middle position?
1.
Run the treadmill at no load and adjust the speed to 6KM/h.
2.
Observe the distance from the running belt to the left and right-side rails.
If biased to the left, use an Allen key and turn the left screw 1/4 turn clockwise.
If biased to the right, use an Allen key and turn the left screw 1/4 turn clockwise.
If belt still in not the middle position, repeat the above method until the belt in middle
position.
3.
After adjusting the running belt to the middle, adjust the speed to 1KM and observe
the deviation of the running belt and the smooth condition. If there is deviation,
repeat the running step.
4.
Warning: Please do not over-tighten the roller, which will damage bearing. If the
above method does not work, you need to tighten the running belt.
11. Important Matter
Summary of Contents for TDA-595
Page 6: ...6 www powermaxfitness net...
Page 7: ...7 www powermaxfitness net...
Page 14: ...14 www powermaxfitness net...
