Powermatic PM2820EVS, Operating Instructions And Parts Manual

Page: 11 / 36

11
Figure 6-10
2. Install three downfeed handles into hub on
either side of drill head (Figure 6-10). Screw
them in completely; use a wrench on the shaft
flats to tighten.
3. Install replacement table into main table (Figure
6-11).
NOTE: The replacement table is removable to
allow installation of an optional specialty table.
See accessories,
sect. 14.0 .
Figure 6-11
4. The replacement table and table insert have
been pre-set so that they are flush. However,
this setting should be checked by the user. See
sect. 6.3.
Figure 6-12
5. Slide fence into t-slots from front edge of table.
To secure fence, push down cam handles. See
Figure 6-12.
6.2.2 Table and insert leveling
1. Position fence across tables and check for gaps
between fence and tables. Do this at several
points front to back.
Figure 6-13
If adjustment is needed:
2. At corner(s) where table is not level, loosen
socket head screw (A, Figure 6-14) slightly.
Then loosen hex nut (B) and turn set screw to
raise (or lower) table at that point.
3. Tighten hex nut (B) and socket head screw (A)
to secure position.
4. Check table insert by positioning fence across it
and tightening down fence.
If adjustment is needed:
5. Remove two screws beneath table insert (C,
Figure 6-14).
6. Loosen nuts (D), then turn set screws as
needed until insert is level with table surface.
Re-tighten nuts (D) up against table.
7. Reinstall the two screws (C) into the table insert.
Figure 6-14