background image

3

English

This product is warranted by Coleman Powermate, Inc. to

the original retail consumer against defects in material and
workmanship for a period of two years from the date of retail
purchase and is not transferable.  This two year warranty
applies only to products used in consumer applications.  If this
generator is used in a commercial application, then the period
of warranty coverage is limited to one (1) year from the date of
purchase.

Please complete and return the enclosed Customer

Information Card so that we can reach you in the unlikely event
a safety recall is needed.  Return of this card is not required to
validate this warranty.

WHAT IS COVERED:

Replacement parts and labor.  

WHAT IS NOT COVERED: 

Transportation charges to

Coleman Powermate, Inc. for defective products.
Transportation charges to consumer for repaired products.
Brushes, fuses, rubber feet, and receptacles.  Damages
caused by abuse, accident, improper repair, or failure to
perform normal maintenance.  Power units or engines which
are covered exclusively by the warranties of their manufacturer.
Sales outside of the United States or Canada.  Any other
expense including consequential damages, incidental 
damages, or incidental expenses, including damage to
property.  Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation
or exclusion may not apply to you.

IMPLIED WARRANTIES: 

Any implied warranties, including

the Implied Warranties of Merchantability and Fitness For A
Particular Purpose, are limited in duration to one (1) year from
the date of retail purchase.  Some states do not allow
limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.

HOW TO OBTAIN WARRANTY PERFORMANCE: 

Replacement parts and service are available from Coleman
Powermate, Inc. Service Centers. Locate your nearest Service
Center by calling TOLL FREE 1-800-445-1805. In the unlikely
event a Service Center can not be located you may call
Coleman Powermate, Inc. for a  return authorization number.

Any unit returned WITHOUT an authorization number will
be refused.

To the extent any provision of this warranty is prohibited by

federal, state, or municipal law, and cannot be preempted, it
shall not be applicable.  This warranty gives you specific rights,
and you may also have other rights which vary from state to
state.

The Idle Control circuit is designed to extend engine life and

improve fuel usage by slowing the engine down to
approximately 2000 RPM in a “No Load” condition. The noise is
also greatly reduced during this condition.

When power is required from the generator an electronic

control module automatically senses current flow in the
electrical outlet and allows the engine to return to full speed or
standard operating condition. Likewise, when the load is
removed, the generator will automatically return to the idle
condition after a 4-5 second delay.

A convenient switch is mounted in the control panel for

easy access and will disable the Idle Control circuitry when in
the off position.

IDLE CONTROL TROUBLE SHOOTING

PROBLEM

POSSIBLE CAUSE

SOLUTION

Unit will not idle

Control panel switch not on

Turn to idle on position

Load plugged into receptacle

Unplug load

Poor connection or faulty cord

Check & repair

Bad I.C. module; Bad electro-magnet

Replace

or solenoids; Bad stator

Consult dealer

Unit idles even with load plugged in

Load not heavy enough

Turn idle switch to off position
Increase load

Bad I.C. module

Replace
Consult dealer

Unit tries to idle but won’t stay latched

Electro-magnet or solenoid position

Reset magnet or solenoid position for

incorrect

2000 RPM idle speed
Consult dealer

Flapper bracket loose or bent

Tighten or straighten
Replace flapper. Readjust to 2000 RPM

Engine not running smoothly

Adjust carburetor
Consult dealer

IDLE CONTROL OPERATION

LIMITED WARRANTY

(NOT VALID IN MEXICO)

Summary of Contents for PM0495502













Reviews: