Questions? Call Toll Free at 1-800-737-2112
Copyright © 2018 MAT Engine Technologies, LLC
ENG - 6
Fig. 2
Drag stake
pointed down
Detent Pin
Assembly
• Save all instructions
Parts Included with Cultivator
• Middle Handle (1)
• Upper Handles (2)
• Wing nuts and bolts (4 ea .)
• Cable Ties (3)
• Operator’s Manual (1)
• 2 .6 fl . oz US bottle of 2-Cycle engine oil (1)
How to Unpack Cultivator from Carton
1 . Remove all parts and packing components .
2 . Use a utility knife to cut all 4 vertical edges . Lay the side
panels flat around the cultivator .
3 . Remove inner components and packaging .
Fig. 1
Lower
Handle
Middle
Handle
Left Upper
Handle
Right Upper
Handle
Wingnut
Bolt
Throttle
Wire
Screw
Throttle
Trigger
If you need assistance or find any parts missing,
CALL TOLL FREE: 1-800–737-2112
WARNING
Do not operate cultivator if it is damaged or not securely and
fully assembled .
CAUTION
Use care when removing parts not to damage any cables or
wires that are attached to the parts .
4 . Roll the unit out from the carton, and place on a hard
level surface .
How to Assemble the Handles and Drag Stake
1 . Place the cultivator upright with tines and wheels on
a hard level surface . Wheels should be set in the
lowest position .
WARNING
Do NOT place the cultivator on a high surface where it can
fall and cause property damage or personal injury .
2 . Assemble the middle handle to the lower handle with the
2 bolts and wing nuts . Refer to Figure 1 . Firmly hand-
tighten the wing nuts .
3 . Attach the upper handles to the middle handle using the
two remaining bolts and wing nuts . Refer to Figure 1 .
4 . Assemble the throttle trigger to the right upper handle with
the screw . Use included wrench . See Figure 1 .
5 . The drag stake is shipped with the point facing upwards .
To use for cultivating, remove detent pin, and turn the
drag stake upside down so the point faces downward .
Re-insert the detent pin . Refer to Figure 2 .
6 . Secure the throttle cable to the handle with FIVE
retaining clips already mounted to the handle . Refer to
Figure 1 .
NOTE:
Use the metal retaining clips to secure the throttle
cable, while use cable tie only to secure the ignition wire .
