LOADING SAFETY
SAFETY IN MOTION
CAUTION: When
transiting a surface, avoid high speed turns that may cause the load
and PowerMate
®
unit to tip. Remember that the load must be secure to the PowerMate
®
unit to ensure the load cannot shift.
When
transiting the unit without a load, ensure the load strapping devices are secure,
not dangling, to prevent a trip hazard and prevent entanglement in the PowerMate
®
moving parts.
Always
keep your attention in the direction you are moving, monitoring clearances
above, below, and each side of the PowerMate
®
and load. When visibility is obstructed
use spotter person for directional instruction and/or clear path of obstacles and un-
involved personnel.
PowerMate
®
Operation Manual
CAUTION: Never
lift a load that is over the rated capacity of the PowerMate
®
unit.
Estimate the weight and center of gravity position of the load and refer to the unit Load
Capacity Chart to ensure the load is within the loading envelope. The capacity may be
limited by the weight and strength of the operator(s). Do not operate with a load that is
beyond the operator's physical ability.
Do not
attempt to increase the load capacity of the equipment by the use of chains,
rope, or other means of securing the equipment to the bed or bodies of vehicles, and
rails, wall brackets, etc.
Operators
shall determine the balance of unfamiliar loads prior moving the load. Work
performed in a balanced condition is done easier and safer. New operators should gain
practice experience with lighter loads of approximately 250 lbs. with a medium center of
gravity before progressing to heavier loads. Do not raise or lower the load too far past
the balance point. Jog the equipment control switches so as not to transfer the load
weight too quickly. Training is mandatory!
Ensure
the load is not damaged, properly packaged, no loose items such as tools used
in packaging the load and sharp items (such as nails) projecting from the load.
Protect
the PowerMate
®
strapping material from sharp edges to prevent strap failure.
Always inspect
straps prior to use.
Insure the strapping latching mechanism is fully
engaged.
Verify
load secureness at the beginning of use, and prior to climbing or descending with
the load.
Check for any loose items or load shifting.
Never
unstrap a load with the PowerMate
®
unit in an open (extended) condition. The
unit will fall over
backwards if the wheels are not in contact with a stable surface when
the unit is unloaded.
Do not
load the PowerMate
®
unit with a load center of gravity that is outside the side to
side limits of the unit wheels.
2.06
PN 013130 Rev.D2
Eng. 12/ 12/ 12
