• Install only on a properly operating Slide Door.
An improperly operating door could cause
severe injury. Have a qualified service person
make any before installing the opener.
• Remove all ropes and remove or make
inoperative all locks (unless mechanically and/or
electrically interlocked to the power unit) that are
connected to the door before installing the
opener.
• Lightweight doors (fiberglass, aluminum etc.)
must be reinforced to avoid door damage.
Check the door manufacturer’s instruction
manual for a bracing procedure or the availability
or a Reinforcement Kit.
• PowerMaster Model SL Slide Door operators
are for Commercial Vehicular Slide Doors and
as such are NOT recommended for pedestrian
traffic. In installations where it is known that
pedestrians will be nearby ensure a pedestrian
door is available for entrance and exit to the
building. In addition YOU MUST install an
auxiliary entrapment protection device (reversing
door edge or photoelectric beam device) as part
of the compete operator system.
• Connect an auxiliary entrapment protection
device (reversing edge or photoelectric device
across the door opening). A device of this type
is
STRONGLY ADVISED FOR ALL
commercial
operator installations. An auxiliary entrapment
protection device is
REQUIRED
when the three
button control station is out of sight of the door
or any other automatic or manual control is
used.
• Install the opener at least 8 feet or more
above the floor.
• Do not connect the opener to the source of
power until instructed to do so.
• Locate the control station:
a) within sight of the door and;
b) at a minimum height of five feet above
the floor and;
c) away from all moving parts of the
door.
• Do not overtighten the clutch adjustment to
compensate for a poorly working door.
• Securely attach any WARNING signs or
placards to both the door and above the control
station.
• After installing the opener, all safety features
must be tested for proper operation (see page
17).
TO REDUCE THE RISK OF SEVERE INJURY
OR DEATH: READ AND FOLLOW ALL
INSTALLATION INSTRUCTIONS!
WARNING
IMPORTANT INSTALLATION NOTES
Item #
Description
Qty.
Item #
Description
Qty.
1
Track Rails
2
9
Drive Chain
1
2
Spreader bracket (s)
As
reqd.
10
Chain Connecting Link
2
3
Idler roller assembly (2 for Bi-part)
1
11
Sway Brace
1
4
Drive/disc. Assembly (2 for Bi-part)
1
12
Sway Brace clip
1
5
Trolley Assembly (standard)
1
13
Hardware package
1
6
Hanger bracket angle
As
reqd.
14
3 Button Station
1
7
Chain Take-Up Bolt
1
15
Trolley Assembly (Bi-Part)
1
8
Operator Power head
1
16
Bi-Part Front Idler Bracket
1
TABLE 1 - COMPONENT IDENTIFICATION LISTING
5
Summary of Contents for SL Series
Page 26: ...Notes ...
Page 27: ...Notes ...