14
4. Turn the engine switch to the “
RUN
” position
5. Warm up the engine without a load for a few minutes.
C Remote start
1. Open the fuel tank air vent to the “
OPEN
” position.
2. Turn the fuel cock lever to the “
ON
” position.
3. Turn the engine switch to the “
RUN
” position.
4. Click
remote
switch to the “
ON
” position.
5. Warm up the engine without a load for a few minutes.
2
）
USING ELECTRIC POWER
1. AC APPLICATION
(a)
Check the AC pilot lamp for the correct voltage reading.
(b) Turn off the switch(es) of the electrical appliance(s) before connecting
to the generator.
(c) Insert the plug(s) of the electrical appliance(s) into the receptacle.
CAUTION:
─────────────────────
z
Make sure that the electrical appliances are turned off before
plugging in.
z
Make sure that the total load is within generator rated output.
z
Make sure that the socket load current is within socket rated
current.
z
The economy control switch must be turned to “
OFF
” when using
electrical appliances that require a large starting current such as compressors, fridges and freezes.
──────────────────────────
2
．
OVERLOAD INDICATOR LIGHT
The overload indicator light will come on when an overload of a
connected electrical appliance is detected, or if the inverter unit
overheats and if the AC output voltage rises. The electronic circuit
breaker will then activate stopping power to the generator in order to
protect the generator and any connected electrical appliances. The output pilot light (green) will flicker and the
overload indicator light (red) will turn on and then the engine will stop running. If so please follow the following
S T O P
R U N
S T A R T
ENGINE
SWITCH
S T O P
R U N
S T A R T
ENGINE
SWITCH
O N
O N
O F F
O F F
O N
S T O P
R U N
S T A R T
ENGINE
SWITCH
