Powerhorse 166112, Owner'S Manual

Page: 34 / 58

Troubleshooting
34
TROUBLESHOOTING
Problem Possible Causes Possible Remedies
Engine will not start. a) Low oil level.
b) Fouled spark plug.
c) Out of fuel.
d) Engine switch in OFF position. a) Fill crankcase to proper oil level.
b) Clean or replace spark plug.
c) Fill fuel tank.
d) Place engine switch in ON position.
Voltage too low. a) Engine speed too slow.
b) Generator is overloaded.
a) Bring generator to a qualified technician for
adjustment.
b) Reduce the load. (See Power Load
Planning & Mgt. section of this manual.)
Circuit breaker trips. a) Defective load connected to
generator.
b) Defective receptacle.
c) Generator overloaded.
a) Disconnect load.
b) Replace receptacle.
c) Reduce the load. (See Power Load
Planning & Mgt. section of this manual.)
Voltage too high. a) Engine speed too high. a) Bring generator to a qualified technician for
adjustment.
Generator overheating. a) Generator is overloaded.
b) Insufficient ventilation.
a) Reduce the load. (See Power Load
Planning & Mgt. section of this manual.)
b) Make sure there is at least 7 feet of
clearance on all sides of generator.
No output voltage. a) Defective load connected to
generator.
b) Broken or loose wire.
c) Defective receptacle.
d) Defective stator.
e) Defective rotor.
f) Circuit breaker tripped.
a) Disconnect load.
b) Bring generator to a qualified technician for
repair.
c) Replace receptacle.
d) Bring generator to a qualified technician for
repair.
e) Bring generator to a qualified technician for
repair.
f) Reset circuit breaker and reduce loads
connected to the generator.
Engine lacks power. a) Generator is overloaded.
b) Dirty air filter. a) Reduce the load. (See Power Load
Planning & Mgt. section of this manual.)
b) Clean or replace air filter.
Engine shuts down
during operation. a) Out of fuel.
b) Low oil level. a) Fill fuel tank.
b) Fill crankcase to proper oil level.