Powerfist 8314106, User Manual

Page: 12 / 32

3-1/2", 28° Framing Nailer
12 For technical questions call: 1-800-665-8685
8314106 V 2.0
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling facility.
TROUBLE SHOOTING (AIR TOOLS)
Problem(s) Possible cause(s) Suggested solution(s)
Tool runs at normal speed but
loses power under load.
Motor parts worn. Have a qualified technician replace worn parts.
Lack of air tool oil. Pour air tool oil into air inlet per instructions.
Tool runs slowly. Air flows slightly
from exhaust.
Motor parts jammed with dirt particles.
1. Check air inlet filter for blockage.
2. Pour air tool oil into air inlet as
per instructions.
3. Operate tool in short bursts
quickly reversing rotation back
and forth where applicable.
4. Disconnect supply. Free motor
by rotating drive shank manually
where applicable
5. Repeat above as needed. If this
fails, bring to service center.
Air flow blocked by dirt.
Excessive air tool oil in tool or buildup
of shipping grease.
Run tool under no load for short periods of time
until exhaust clears.
Tools will not run. Air flows freely
from exhaust.
O-rings throttle valve dislodged from
seat inlet valve.
Have a qualified technician replace the O-ring.
Damage to, or excessive wearing of
internal parts
Bring to service centre
Tool will not shut off.
O-rings throttle valve dislodged from
seat inlet valve.
Have a qualified technician replace the O-ring.
Loss of power or
erratic performance.
Excessive drain on the air line.
Moisture or restriction in the air hose.
Incorrect size or type of
hose connectors.
Check the air supply. Ensure tool is connected
to a 3/8” I.D. or larger air hose with no kinks or
restrictions and that the fittings are
connected properly.
Air compressor has insufficient flow.
Ensure tool is connected to a compressor whose
rated flow matches the tool.
Note: Repairs should be carried out by a qualified person