10
Safety Information
1.4
Maintenance information
• The maintenance work and mainte-
nance intervals prescribed in the op-
erating manual must be adhered to.
• Operating personnel must complete
the necessary daily and weekly
maintenance work. All other mainte-
nance work must be completed at
your nearest PowerBoss service
center.
• The machine must be inspected by a
recognized technical expert in re-
spect of operational safety, within
the terms of the applicable accident
prevention laws, at reasonable inter-
vals (we recommend at least once a
year) and following modification or
repairs.
• Spare parts must comply with the
minimum technical requirements
stipulated by the manufacturer! This
is ensured by the use of original
spare parts.
• The machine must be switched off
prior to cleaning or servicing it or to
replacing parts.
• Suitable tools must be used for
cleaning and maintenance work.
• When working with the hood raised,
it must be opened up fully to prevent
it from accidentally dropping or slam-
ming shut.
• When working on the electrical sys-
tem, always disconnect the battery
cable (only PowerBoss Collec-
tor 34 B).
• Batteries may only be handled and
changed by properly skilled mainte-
nance personnel (only Power-
Boss Collector 34 B).
• Pay attention that the insulation of
the charger cable is not damaged
and cannot be damaged during the
charging process. The cable must
not chafe against anything. In the
case of defective insulation, do not
use the on-board charger (only Pow-
erBoss Collector 34 B).
• Check the exhaust system at regular
intervals (only PowerBoss Collec-
tor 34 G).
• It is not permitted to clean the ma-
chine with a pressure washer or
steam blaster.
• It is not permitted to use aggressive
and corrosive cleaning agents.
• Allow the machine to dry properly
after being cleaned, e.g. over the
weekend.
• Do not carry out any welding, drilling,
sawing or grinding work on the frame
sections. Damaged parts may only
be changed at an authorized Power-
Boss service center.
