31
Machine Overview
Rear Squeegee Adjustment
1.
Ensure that the scrubber is on a relatively flat surface. Turn on the key switch and select the
Vacuum only
mode. This lowers the
squeegee to the floor and turns the vacuum motor on.
2.
Move the scrubber one or two feet forward slowly while someone behind the machine checks the rear squeegee blade (item
A
) for uni-
form deflection to the floor.
3.
If uneven deflection or lay is evident, minor adjustments may be necessary to avoid streaking and uneven wear on the blade.
4.
To correct this, loosen the wing jam nut (item
B
) in order to adjust the caster height. If the squeegee blade is deflecting too much, the
casters (item
C
) need to be lowered to control the down pressure. Lower the caster by turning the exposed threaded stem (item
P
) on
the caster clockwise. Make the adjustment a few turns at a time.
Repeat step 2
.
5.
If the blades are not deflecting enough, raise the caster by turning the stem counter-clockwise to adjust the caster height to allow more
down pressure on the squeegee.
Repeat step 2.
6.
Make sure there is even deflection on the entire length of the rear blade. Adjust the casters and retighten the wing jam nuts to lock the
caster setting in place.
7.
Pitch adjustment is necessary if the outer ends on the squeegee blade do not contact the floor and there is too much deflection in the
middle area or if the outer ends are over deflected and there is no contact in the middle.
8.
To adjust the pitch, repeat step 2.
9.
Loosen the two wing jam nuts (item
D
) that lock the pitch angle. Turning the knob (item
E
) clockwise or counter-clockwise controls the
forward and backward pitch of the squeegee. Having the rear blades deflected uniformly along its entire length is the desired set-up.
10.
Repeat step 2 until desired set-up is achieved.
11.
In certain applications where a non-slotted front wiper blade (item
F
) is needed, detach the rear squeegee assembly by loosening the
two wing bolts (item
G
). Unlock the toggle clamp (item
H
) on the front squeegee to release the front long strap (item
I
) and slide the front
short strap (item) (
J
). Flip the blade over to the non-slotted side. Reattach the straps and lock the clamp back in place.
12.
You can also easily replace the rear blade by unlatching the latch (item M) and removing the two rear straps (items K & L) by sliding
them off the assembly. You can then flip the blade over in order to use a new edge for better wiping action.
Summary of Contents for Admiral 28
