11
PB450 US - W18XC1053/US - Revised 030113
UNPACKING AND ASSEMBLY
The Powerbor PB450 comes in a rugged blow moulded carrying case before first use:-
1.
Remove the machine from the carrying case. (Note:- 44lb weight)
2.
Fit the three screw in handles to the pinion shaft.
3.
Fit the safety guard as shown in the instructions, see “Using the safety guard”
4.
Fit the arbor, as detailed in the instructions under “Fitting the MT2 Arbor”
SETTING UP THE TOOL
Before using the tool please ensure you have read the sections on the intended and
prohibited of use of the machine.
The machine should only be used for hole drilling whilst attached to the work piece by the
electro-magnetic base.
This machine is intended for use at any angle, but only if the electro-magnet is in full
working order and has sufficient hold on the work piece material.
The safety strap should be attached in case of power failure or machine malfunction.
The safety strap should NOT be used as an alternative to the magnet for clamping
purposes.
Always ensure the strap is correctly fitted and the machine is secure BEFORE starting
CONNECTION TO THE POWER SUPPLY
Connection to the power supply is by 8‟ 2” long cable and 3 pin plug.
This tool is CLASS I insulation and MUST be earthed, any power socket the tool is
connected to must have an earth.
Before the power cord is connected the magnet switch should be in the OFF position.
The power cord assembly is a custom terminated one, replacement should only be
carried out by a qualified electrician. Only use the replacement parts listed below.
Power cord part number:-
18X503/A
For connection information, should the power cord need to be replaced, please refer to
the wiring diagram in this manual or the connection label inside the rear panel of the
power tool.
