7
WIRING AND CONNECTIONS
The PowerBass Air Suspension subwoofer system consists of a single 4-ohm voice coil woofer. Check to see
that your amplifier is optimized to drive this load.
A single spring loaded push terminal cup provides a quick and easy connection from your bass amplifier to
your Air Suspension system
1/2”
The push terminal input cup is located on the side of the enclosure (Fig 1). For a bare wire connection, strip
1/2 inch (12.7mm) of insulation from each of the two conductors of your speaker wire (not included) to expose
bare metal (Fig 2). Carefully twist each of the conductors to eliminate any frayed ends. Push open both termi-
nals, line up the holes, and insert the wires from your amplifier as follows: Positive wire (+) to the Red terminal,
Negative wire (-) to the Black terminal. Be careful not to insert the insulated part of the wire into the hole as
this will not give you a good connection.
Fig.1
Fig.2
PS-WB110T
4 o
hm
Sy
ste
m
Im
pe
da
nc
e
27
5w
at
ts
RM
S
•
55
0w
at
ts
Pe
ak
Summary of Contents for PS-WB110T
Page 2: ......
