Lever/
Push
Stick
PF05
POST
- 10 -
CARE AND ENVIRONMENT
ASSEMBLE A DRILL PRESS
START / STOP
Use the Green and Red Start / Stop
buttons to start and stop the tools
fitted to the case.
Open the case lid and remove any
fitted tools, then close the lid and lock
the 2 latches.
Insert the Post/Fence vertically into the
rear of the case with the small hook
toward the rear of the case.
Push it down until
it locks into
place, to adjust
the height
or
remove the
post you can
lift the Vertical
Post Release.
Rotate the
large end over toward the
front of the case until it locks in place. If
you want to unlock it, press the 2 Metal
Buttons on the sides of the Post and
rotate back again.
NOTE!
This page refers to parts not included in all packages.
General inspection
Regularly check that all the fixing screws are present and
tight, they may vibrate loose over time. Keep the tool’s air
vents unclogged and clean at all times.Remove dust and
dirt regularly.Cleaning is best done with compressed air or
a rag.
CAUTION,
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool.After each use, carefully clean the tool with a brush
or rag.Clear any debris from around the battery mount,
moving parts and clips.
Lubrication
No internal lubrication is necessary, the bearing area is
sealed. A coating of machine oil on the metal parts will help
prevent corrosion.
Storage
Store the tool, instruction manual and accessories in a
secure, dry place.In this way you will always have all the
information and parts ready to hand. Lithium ion batteries
should ideally be stored with 40 to 80% capacity between
10ºC and 20ºC (50ºF and 68ºF).
WARNING!
Always charge Li-ion batteries before storage
and at least every 3 months to prevent permanent damage.
Environment
When the time comes to dispose of this product please
consider the environment and take it to a recognised
recycling facility instead of disposing with general
household waste.
Call your local council, civic amenity site, or recycling centre
forinformation on the recycling and disposal of electrical
products andbatteries. If you do not have access to suitable
disposal facilities in your area please contact your place of
purchase, they will advise you on the
best way to dispose of your product.
Maintenance
All electrical parts should be regularly serviced by an
approved engineer.
Hold the Drill firmly and align its Rails with those on the
Post. Slide the drill firmly and sharply upward until it locks
into place. The 2 Locking Clips will spring toward the drill
when it is locked in place, pull these away from the
drill when you want to remove
it. Fit the Lever/Push Stick
into the 2 Lever Holes on
either side of the Post and pull
downward to press the drill
down. The Work Clamp can
also be used to hold your work
when a small drill bit is fitted.
