1
2
- 9 -
FITTING/REMOVING A BIT
OPERATING THE TOOL
Chuck Collar
- Twist
Torque Selection Ring
- Twist
Select hammer mode, drill mode or a torque setting
Twist the Torque Control Collar so the required setting is aligned
with the arrow on top of the drill.
Hammer action is indicated by the hammer symbol.
Drilling mode is indicated by the drill symbol -the clutch is disabled
for maximum torque.
Align a number to the arrow to set drive torque, a lower number
will apply less torque to the chuck -driving a screw until the clutch
disengages the chuck- a high number will drive a screw deeper.
To switch between high and low gear
Release the trigger and allow
the drill to stop. Slide the Gear
Selector backward away from the
chuck for high gear and high
speed drilling,
2
will be
displayed.
Tip, use high speed for small
diameter drill bits.
Slide toward the chuck of the drill to select low gear for low
speed and higher torque
1
will be displayed.
Tip
, use low speed for large diameter drill bits and driving
screws.
WARNING!
Wear safety equipment when handling sharp
bits and when operating tools.
To change drive direction
Press the Direction Switch on
the UniGrip, it has 3
positions.The centre position
locks the trigger, the other
positions will turn the chuck
clockwise or anti-clockwise.
Note!
Always use the locked position when fitting or
adjusting a bit or driver.
Note!
When drilling always use the clockwise direction
except to free a jammed bit.
To change a drill bit or driver
Lock the trigger by selecting the middle position.
Choose an appropriate bit, see the following section.
Rotate the Chuck so that the jaws are just wide enough
to accept the bit.
Ensure enough of the drill/driver bit is held by the jaws,
at least 10mm or 25% should be within the jaws.
Check the bit is centred in the jaws and tighten
securely.
Note!
Before using the bit briefly activate the drill to
ensure the bit is centred and secure. If the end of the
bit wobbles when rotating then loosen and re-fit.
The electric
brake will
engage
with a battery
connected as
long as the
trigger is not
pressed. Grasp
the single collar
chuck and the
drill body and
rotate the Chuck
to loosen or
tighten the jaws.
