Istruzioni per l’uso e manutenzione
Cod. OQ7.5ARG114 – GB
Emiss. 19-01-11 Rev. 0 - Agg. /
22
POWER SYSTEM SRL
Via dell’Emigrante, 11/13 - 36040 Brendola (VI) Italia
10.1 GENERAL
WARNINGS
IT IS ABSOLUTELY FORBIDDEN TO USE AIR PIPES AND COUPLINGS THAT ARE NOT
SUITABLE AND/OR DO NOT COMPLY WITH THE REGULATIONS IN FORCE.
DURING COMPRESSOR OPERATION IT IS FORBIDDEN TO DISCONNECT THE
PRESSURISED AIR PIPES. THERE IS A RESIDUAL RISK.
IT IS OBLIGATORY TO INSTALL THE COMPRESSOR IN A PLACE WITH ADEQUATE
VENTILATION WHICH ENABLES THE AMBIENT TEMPERATURE TO BE MAINTAINED
B2 °C AND +40 °C, WITH HUMIDITY BETWEEN 5 AND 95%.
IT IS OBLIGATORY TO CONTACT THE MANUFACTURER OR AUTHORISED DEALER IN
THE EVENT OF AN INADEQUATE OUTPUT OF HOT AIR FROM THE PLACE IN WHICH THE
COMPRESSOR IS INSTALLED.
THE AIR SENT INTO THE PLACE WHERE THE COMPRESSOR IS INSTALLED MUST BE
CLEAN AND FREE FROM DUST, FUMES AND INFLAMMABLE VAPOURS.
10.2 POSITIONING
The compressor must be positioned in the place of installation and use in conformity with the provisions in the table of
“Technical data”.
IT IS OBLIGATORY TO ENSURE THE MINIMUM POSITIONING MEASUREMENTS GIVEN
IN FIG. 6.
IT IS OBLIGATORY TO SECURE THE COMPRESSOR TO THE GROUND WITH THE FEET
PROVIDED, USING SCREWS SUITABLE FOR THE PURPOSE.
TO ENSURE THAT THE AUTHORISED OPERATORS ARE ABLE TO OCCUPY THE WORK PLACES
CONTEMPLATED IN FIG. 11, IT IS OBLIGATORY TO RESPECT THE MINIMUM POSITIONING
MEASUREMENTS GIVEN IN FIG. 6.
10.3 SECURING THE COMPRESSOR AND CONNECTING THE AIR PIPE
After having respected the minimum positioning measurements given in
FIG. 6
it is necessary to anchor
the feet to the floor with screws suitable for the purpose.
After having positioned and secured the compressor correctly, proceed as follows:
1) Connect the pipe to the air output fitting on the compressor
(FIG. 6 - Ref. 8
);
2) Connect the pipe to the air input fitting of the pneumatic system
(FIG. 6 - Ref. 8
).
10.4 TEMPERATURE BELOW 0° C
1. Ensure that the control lines, the drains and the siphons are heated so as to avoid freezing of the condensate.
2. A simple roof must be provided in case of rain or snow.
3. Use only oil suitable for low temperatures (consult Power System).
