LEVC Specifications
Compatible battery chemistries
NiCd / NiMH / Li-Ion / LiPo
Recommended operating temperature
15° C – 30° C / 59° F – 86° F
Storage temperature
0° C – 65° C / 32° F – 149° F
Power supply input
12V – 24V DC @ 1.0A (minimum)
Charge rate
700 mA
DC power cable
16 AWG / 5A in-line fuse / 3.0 m (9.8’)
Controller to radio holder interface cable
2.0 m (6.6’) / RJ45 connectors
Fault Conditions
When the charge status LED flashes RED, a fault condition exists. The LED flash patterns
and fault conditions are as follows:
Flash Pattern
Fault Type
Flashes 1 Time
Indicates charging complete, but battery is under charged. Battery voltage
is below the minimum level required. This warning is provided after the
rapid charging stage is complete.
Flashes 2 Times
Indicates battery contact is “open” and current is not passing through the (+) and
(-) contacts on the battery. This warning is provided after the initial
diagnostic stage is complete. Check radio holder to confirm compatibility
with battery.
Flashes 3 Times Indicates over-current condition caused by battery short circuit. Have the
battery checked by a qualified technician. Do not attempt charging the
battery if a short circuit exists.
Warranty And Service During Warranty
The Logic Energy In-Vehicle Charger is made from high quality materials and designed to provide years of
reliable service. The following warranty applies:
Power Products Unlimited, Inc. (PPU) warrants this product to be free from defects in workmanship and materials
for two-years from date of purchase by the end user. This warranty applies to the original purchaser and is void
if the product has been altered, misused, damaged, neglected, or if repair is required because of normal wear
and tear. This is the only warranty made by PPU. In no event will PPU, its affiliates, subsidiaries, related entities,
or their respective directors, officers, or employees, be liable for any damages beyond repair or replacement
as described above, including without limitation, indirect, incidental, or consequential damages. For service
under warranty, return the product along with dated proof of purchase to the dealer where purchased or to
Power Products. If returning directly to Power Products, follow these instructions:
Send to Power Products – Warranty Service Department, 2170 Brandon Trail, Alpharetta, GA 30004. For your
protection, we recommend you obtain proof of delivery for your shipment.
Include with your product, dated proof of purchase, your name and daytime telephone number, email address,
and return address (a U.S. street address only; return shipments cannot be made to a P.O. Box or locations
outside the U.S.).
All items sent become the property of Power Products and will not be returned.
© 2012 Power Products Unlimited, Inc. Power Products is a registered trademark of Power Products Unlimited,
Inc. Logic Energy and Charging Solutions For Professionals are trademarks of Power Products Unlimited, Inc.
All rights reserved.
Charging Solutions For Professionals™
