Operation and installation manual
Page 45 of 96
(PVI-STRINGCOMB (-S, -MC, -S-MC) - Rev:1.0)
9.3.5 Antitheft system input / output
Remove the jumper (J) provided as standard and connected between the
terminals 7-8 of the Terminal Block A (Figure 9-11).
Connect the antitheft system input wire as shown in Figure 9-10, Figure 9-11,
Table 9-4.
The alarm wire (a normal wire) is not supplied as standard and shall be
adjusted according to system complexity.
Make sure that overall wire resistance is below 400
Ω
.
Figure 9-10: Example of antitheft system connection
A
Alarm_IN-
