Power Fist 8986739, Manual

Page: 8 / 28

1. Select an indoor wall or ceiling location within four feet of a grounded
electrical outlet. The mounting location must have solid construction.
Drywall will not hold the reel in place.
a.
Install the reel no higher than 15 feet above the floor.
b. Check that the power at the outlet conforms to the rating for the reel
(see Specifications).
2. Locate a wall or ceiling beam (use a stud finder, if needed) and using the
mounting bracket as a template, mark the holes so they are centered on
the beam.
3. Screw the cement or wood screws into the marks, leaving the screw
heads slightly raised above the surface.
4. Slide the mounting bracket onto the screws. Finish tightening the screws
to hold the reel in place.
5. Adjust the cord stopper to the suitable position when required.
6. Loosen the screw holding both halves of the stopper enough to slide the
stopper. Pull out the extension cord until enough is hanging out. Slide the
stopper to the desired location, then tighten the screw to lock it in place.
Pull the extension cord and allow it to retract to the stopper.
OPERATIONS
WARNING! Do not let go of the extension cord while retracting or
extending. The cord may whip around during retraction and cause an
injury by striking a bystander. The tool’s mechanism may also be
damaged.
1. Slowly pull out the amount of the extension cord required for the task. A
click will be heard every half rotation of the internal drum.
•
Pull on the extension cord, not on any tool plugged into the cord.
2. Latch the extension cord in place by allowing it to slowly retract back into
the reel case after a click. The extension cord will feel slack when latched.
8986739 STEEL RETRACTABLE EXTENSION CORD REEL V1.0
www.princessauto.com / 1-800-665-8685 Page 8