V1.0
5 in. Air Angle Grinder
8843534
Visit www.princessauto.com for more information
11
INSTALL THE GRINDING WHEEL
Accessories such as specialty wheels are installed in the same manner as a
grinding wheel.
1.
Insert the wrench (#45) behind the rear flange nut (#15) to hold the
spindle by the flat sections.
2. Insert the pin wrench (#44) pins into the front flange nut openings (Fig. 2).
Turn the wrench counterclockwise to loosen the nut.
3.
Remove the front flange nut (#19) from the spindle (#13).
4.
Mount a 5 in. grinding wheel onto the spindle. Make
sure the wheel is properly oriented with the printed
face against the angle grinder.
5.
Screw the flange nut onto the spindle. Tighten with
the wrench and pin wrench by turning clockwise.
OPERATION
1.
Clean the angle grinder of packing grease before first use. Also grease the
spindle gears. See the Air Tool Lubrication section for instructions.
2.
Rotate the wheel guard to the left or right to maximize user protection when
grinding. Remove all cap screws (#18) and spacers (#17) with a hex wrench
and re-position the guard. Put the spacers on the screws and re-secure.
3.
Install the grinding wheel (See Assembly & Installation). The type of
grinding wheel installed will depend on the material and task.
4.
Connect the tool to the air source.
5.
Set the compressor to the correct air pressure and flow (see Specifications).
Start the compressor.
6.
Hold the angle grinder by the handle (A) and rear body.
7.
Push the trigger lever safety (D) forward to free the trigger lever (E).
8.
Squeeze and hold the trigger lever to increase the grinding wheel speed. Wait
until the wheel has reach full speed before applying it to the material.
9.
Test the tool under no load to confirm the grinding wheel is installed
correctly.
10. Hold the angle grinder and apply the leading edge of the grinding wheel against
the material, so the debris is moved away from the work area. Do not press
down too hard, as this can cause the wheel to slow or gouge the workpiece.
11. Lift the angle grinder from the material and slowly release the trigger lever.
The trigger lever safety will automatically snap back into place.
Fig. 2
