V4.0
Roof Mounted Cargo Carrier
8681835
Visit www.princessauto.com for more information
5
plate, spacer tube and clip. Insert a M6*40
bolt (#9) through each of the 3 bolt holes
on the plate’s bottom (Fig. 3).
4. Insert a M6*25 (#2) bolt through each of
the bolt holes in the plate’s top (Fig. 3).
5 Secure all 6 bolts with an M6 locknut (#11)
(Fig 3).
6. Slide the front platform (#5) into the rear
platform (#1) until all four parts of the
frame are seated (Fig. 4).
7. Attach the side plates (#12) and secure each
side with two M6*16 screws (#13) (Fig. 4)
8. Position two U-bolts (#14) under each roof
bar. Place a bracket saddle (#15) onto each U-
bolt so the roof bar is trapped
between the saddle and U-bolt
(Fig. 5).
9. Place the roof rack onto the
bracket saddles. The frame’s
bottom crossbars should sit on
the brackets without interfering
with the U-bolts (Fig. 5)
10. Loosely secure the U-bolts with knobs (#4). Once all four bolts are secure,
begin tightening the two knobs on each bolt a little, then move diagonally
across to the next U-bolt and tighten it. Repeat until the roof rack is held
tightly by all four U-bolts.
CARE & MAINTENANCE
1. Maintain the device with care. A device in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the device components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Only use accessories intended for use with this device.
Fig. 3
Fig. 4
Fig. 5
