V4.1
2 in. Gas Water Pump
8509978
Visit www.princessauto.com for more information
23
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
PROBLEM(S) POSSIBLE CAUSE(S)
SUGGESTED SOLUTION(S)
Engine will
not start.
1. Engine is cold.
2. Fuel valve in OFF
position.
3. Engine switch is in OFF
position
4. Engine oil is low.
5. Out of fuel.
6. Bad fuel, engine stored
without treating or
draining gasoline or
refueled with bad
gasoline
7. Engine is flooded
8. Spark plug fouled/fails
to produce a spark.
9. Fuel filter restricted,
carburetor
malfunction, ignition
malfunction, valves
stuck, etc.
1. Move choke to CLOSED position until
warm, then move to the OPEN position.
2. Move to ON position
3. Move to ON position
4. Fill with the recommended oil to the
proper level.
5. Refuel
6. Drain fuel tank and carburetor. Refuel
with fresh gasoline.
7. Move choke to OPEN/RUN position and
attempt to start the engine.
8. Remove and clean spark plug. Check
electrode spacing and set the gap to
the correct dimension. Replace spark
plug if damaged. Ensure the spark plug
lead is installed and connected.
9. Replace or repair faulty components as
needed. Contact Princess Auto Ltd or
take engine to an authorized service
center if necessary.
