tool USE
During sharpening operations, follow these instructions:
1. Place the chain on the guides (see fig. 6).
2. turn the chain support through 30° and tighten the lock nut (see fig. 7).
The 30° angle increases the
tooth angle for a better quality cut. However, less material must be removed, since increasing the tooth
angle also increases its fragility, leading to greater risk of chain breakage.
3. set the tooth in line with the abrasive wheel using the adjuster screw (see fig. 8).
4. tighten the chain slightly using the knob (see fig. 9).
5. adjust the sharpening depth using the screw provided (see fig. 10).
6. tighten all the teeth of the same type before turning the chain support to the other side with the
same angle (see fig. 11 and 12).
7. the chain support position must only be changed when the tool is off.
8. to avoid damaging the chain teeth, remove as little material as possible and do not work too long
on any one tooth.
The maximum amount that can be removed from each single tooth varies from chain
to chain; this information must be supplied by the chain’s manufacturer (read the instructions supplied by
chain’s manufacturer).
9. sharpen the depth limiters using a flat file for use on steel (see fig. 13).
CommiSSioning
InstallatIOn
the following parts are needed :
stopping pin
•
13 mm spanner
•
Grinding wheel
•
1. use the m8 bolt to fix the unit onto the worktable properly.
2. the unit must be installed, as shown in fig. 6 and fig. 1. the operator must be parallel with the
worktable and the machine and push the handle while sharpening the chain.
PrelImInary checKs
with the machine at a standstill check:
The wheel’s condition and profile
•
The condition of the electrical connection lead
•
That the machine is securely fixed to the workbench
•
after connecting the power supply plug and starting the tool, make a visual check that the
wheel does not wobble in either direction. replace the wheel if necessary.
tool USE
startInG
1. after making all the preliminary checks and putting on the specified polypropylene (goggles,
mask, ear plugs, gloves) follow the start-up instructions carefully.
2. fit the chain.
3. connect the plug to the power supply socket.
4. Press the hold-down’ start button and keep it depressed.
5. sharpen the chain.
for any technical questions, please call 1-800-665-8685
6
8252165
