Inserting Bits
(See figure 4)
1. In order to insert a drill bit or
screwdriver bit, grasp the back
section of the chuck (2) and rotate
the front section of the chuck (1)
until the bit fits.
2. Insert the bit (or screwdriver bit
holder) as far as it will go into the
drill chuck opening.
3. Clamp in the screwdriver bits using
the bit-holder.
4. Select screwdriver bits appropriate
to the screw head in order to avoid
damage to the screws.
5. Firmly tighten the chuck by hand.
Check whether the tool is firmly
seated in the drill chuck.
Switching On and Off
(See figure 5)
Set rotating direction switch (1) to the
desired position. Press ON/OFF switch
(2) to turn on the drill. Release the
ON/OFF switch to turn off the drill.
Forward and Reversing Switch
The rotation direction can be changed from clockwise to counter
clockwise with the rotation direction switch. This switch is locked
when the tool is operating. The counter clockwise direction is useful
for removing screws and nuts.
Caution: Check the direction of rotation before use. The rotation
direction can only be changed when the drill is not in
operation.
Note: Extended periods of drilling at the lowest speed increases the
danger of overheating the motor. Every 15 minutes, allow the
motor some time to cool.
F
Fiig
gu
urre
e 4
4
F
Fiig
gu
urre
e 5
5
