Initial Operation
(See figure 2)
1. Insert the charged battery (2) in the
handle of the drill (1) and secure
with the release button (3). The
spring must snap into place.
2. Separate the battery from the tool by
pressing the release button below the
machine handle.
Charge process
(See figure 3)
1. Insert the power plug (1) of the
charger into a power outlet (up to
120V). The green indicator (4)
should light up.
2. Carefully insert the battery pack (3)
into the base of the charger (2) in the
correct direction. Do not insert the
battery pack the wrong way around.
3. The red indicator (5) will then light
up, indicating that the battery pack is
charging. This process will take 1 to 1-1/2 hours.
4. When the red indicator switches off and the green indicator is lit
again, the battery pack is fully charged. Remove the power plug
from the outlet, and the battery pack from the charger. The battery
pack can be used immediately.
Caution:
• The battery pack needs to be charged before you first use your
machine. It reaches its full capacity after several charges.
• Avoid repeated consecutive rapid charges of the battery. Do not
recharge after using only briefly, such as after 15 minutes of use.
• The battery pack and charger will become warm during the charging
process. This is not a malfunction.
F
Fiig
gu
urre
e 2
2
F
Fiig
gu
urre
e 3
3
