2.9 GPM @ 2,500 PSI Electric Wall-Mount Pressure Washer
14
For technical questions call 1-800-665-8685
8242273
V 2.9
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a listing of disposal facilities or by-laws for electronic devices, batteries, oil or other
toxic liquids.
WARNING! DO NOT pollute the environment by allowing uncontrolled discharge of waste oil.
TROUBLESHOOTING
Contact Princess Auto Ltd. for a solution if the tool does not function properly or parts are missing. If unable to do so,
have a qualified technician service the tool.
Problem(s)
Possible cause(s)
Suggested solution(s)
Motor won’t run
No electric power
Plug into receptacle
Thermal breaker
Let motor cool for 5 minutes with the
switch OFF
Circuit breaker
Reset circuit breaker
Voltage drop. Extension cord is too
long or too light gauge. Power supply
is low.
Check power supply. Use a longer
high pressure discharge hose instead
of an extension cord.
Pressure loss
Unloader valve has been loosened
(turned counterclockwise).
Turn unloader clockwise until it locks
at original factory preset position.
Hose inlet filter clogged.
Remove and clean.
Air in water.
Tighten all water hose fittings.
Nozzle worn.
Replace nozzle.
Pump worn.
Rebuild or replace pump.
No water at nozzle
Water supply off
Turn on water supply
Hose inlet filter-washer plugged
Remove and clean
Plugged nozzle
Clear obstruction by blowing air back
through nozzle.
