Power Fist 10 in. Bench-Top Drill Press, User Manual

Page: 10 / 40

8654337 10 in. Bench-Top Drill Press V 4.0
2. Avoid long and regular bursts of energy while operating the tool. Use the
tool for short or intermittent periods of time. This will prevent a pacemaker
from interpreting the signal as a rapid heartbeat.
3. Alert other people in the work area, so they can take precautions or can
watch out for those with a pacemaker.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
missing part before operating. Failure to do so could result in a malfunction
and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
MOUNTING
Secure the tool to a supporting structure before use. Before assembly, bolt the
Base to a flat, level, solid workbench capable of supporting the weight of the
drill press and any workpieces. Verify that installation surface has no hidden
utility lines before drilling or driving screws.
ASSEMBLY
1. Column to Base.
a. Place Column (#6) on the Base (#1) and align bolt holes in the
Column and Base.
b. Attach using Bolt (#5), Washer (#3) and Spring Washer (#4) in each
hole through the Column and into the Base.
2. Table Support.
a. Place the Table Support (#21) over the Rack (#7).
b. Slide the Table Support over the Column (#6).
c. Slide the Collar (#16) over the Column (#6) with the beveled edge
facing down until it presses against the top of the Rack (#7). Tighten
the Set Screw (#17), but do not overtighten it.
10 For technical questions call 1-800-665-8685