1.6 GPM @ 2,000 PSI Electric Pressure Washer
4
For technical questions call 1-800-665-8685
8465437
V 3.01
Polarized Plug
Double insulated tools eliminate the need for a 3-wire grounded power cord and grounded power supply system.
The tool is equipped instead with a polarized plug that requires a polarized outlet/power supply.
1. A polarized plug has two blades of different widths, allowing only one way to insert the plug into the outlet.
2. Reverse the plug if it does not fully fit into the outlet.
3. If the outlet does not accept a polarized plug, contact a qualified electrician to install a polarized outlet.
4. Do not alter the plug as this may compromise the built-in safety feature.
WARNING! All wiring should be performed by a qualified electrician.
Power Cord
1. Insert the power cord plug directly to the power supply. Do not use extension cords or surge protectors.
2. Do not operate this tool if the power cord is frayed or damaged as an electric shock may occur, resulting in
personal injury or property damage.
a. Inspect the tool’s power cord for cracks, fraying or other faults in the insulation or plug before each use.
b. Discontinue use if a power cord feels more than comfortably warm while operating the tool.
c. Have the power cord replaced by a qualified service technician
3. Keep all connections dry and off the ground to reduce the risk of electric shock. Do not touch plug
with wet hands.
4. Prevent damage to the power cord by observing the following:
a. Never use the cord to carry the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the power cord clear of the tool and the tool’s work path while in operation. The cord should always
stay behind the tool.
d. Keep cord away from heat, oil, sharp edges or moving parts.
e. Do not allow people, mobile equipment or vehicles to pass over unprotected power cords.
i. Position power cords away from traffic areas.
ii. Place cords in reinforced conduits.
iii. Place planks on either side of the power cord to create a protective trench.
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify or alter this
tool or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the ignition switch/trigger is in the neutral or OFF position when not
in use or before connecting it to any power source.
