![background image](http://html.mh-extra.com/html/power-craft/4500/4500_instruction-manual_1586269021.webp)
21
ENGLISH
INSTRUCTION MANUAL
1 Plug
2 Charger
3 Battery
4 Red and green indicator
Warning!
1. The battery must be fully charged before using
the drill for the first time. The battery does
not reach full capacity until it has been
charged several times.
2. Avoid charging the battery excessively. The
battery must not be charged if it has only been
used for a short period, e.g. 15 minutes.
3. The battery and charger will become warm
during charging. This is not a fault.
Inserting drill bits and screwdriver
bits
Follow the instructions below when inserting drill
bits and screwdriver bits:
Hold collar number 2 and turn collar number 1;
the drill jaws will open.
Insert the drill bit as far as possible into the jaws.
If using screwdriver bits, use the bit holder, which
is one of the drill’s accessories.
Now tighten collars 1 and 2 by hand.
Select a bit suitable for the screw to avoid
damaging the screw head.
Switching on and off
Set the direction of rotation button to the
desired position.
To switch on, press the ON/OFF button (2)
To switch off, release the ON/OFF button (2)
Forward and reverse
Use the direction of rotation button.
Use either R (for clockwise motion).
Or reverse (for anticlockwise motion).
When the ON/OFF button is activated, the forward
and reverse switch is deactivated.
Using the lowest speed of rotation for long
periods increases the risk of overheating the
motor. The drill should not be run constantly at
low speeds for periods longer than approx. 15
minutes.
Mechanical gear control
You can increase the speed of rotation by pushing
the gear button forwards to position 2.
This produces a speed of rotation of
0-1,150 rpm.
You can also reduce the speed by
pushing the gear button back to position 1.
This produces a speed of rotation of
0-400 rpm.
1
2
1
2
3
4
Summary of Contents for 4500
Page 28: ...28 EXPLODED VIEW PART LIST ...