Power Computing PowerCenter Pro Low Profile 180/210, Manual

Page: 9 / 30

CONFIDENTIAL
9
N N N Nooo otttteee e::::
All DIMMs must be 168-pin, fast-paged mode, 60-nanosecond RAM access time or faster. The
PowerCenter has four DIMM slots near the front on the motherboard. DIMMs may be installed in
any slot.
Removing RAM
1. Remove the chassis cover (
refer to Chassis Cover Removal/Installation on page 6).
2. Locate the DIMM(s) you would like to remove
(see Figure 3: on page 9).
Loosen the desired DIMM
module by reaching in and pushing down on the small lever at the end of the DIMM slot.
(see Figure 4:
Removing RAM on page 9).
The DIMM should pop loose from the slot at the lever end.
3. Grasp the DIMM module on each end and evenly pull the module up and out of the slot.
Installing RAM
1. Hold the module (with the contacts down) with one hand at each end. Notice that there are two
notches in the contact edge of the DIMM module.
2. Lower the DIMM squarely into the slot so that the notches in the DIMM line up with the notches in the
slot. Slide the contacts straight into the slot and make sure the contacts are firmly seated.
(see Figure 5:
Installing RAM on page 10).
When properly seated, the contacts on the bottom should not be visible.
RAM Removal/Installation
RAM Removal/Installation
Figure 3:
DIMM slot
location
Figure 4: Removing RAM
DIMM Slots
RAM