5
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(1) Screwdriver
(1) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
(2) 1/2" wrenches
OPERATOR’S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
ASSEMBLY
Fig. 1
(2) Hairpin Clips
(1) Cable Clip
(1) Carriage Bolt 3/8-16 UNC x 1 Gr. 5
(1) Center Locknut 3/8-16 UNC
(1) Handle Lock Lever
(2) Handle Locks
(1) Flat Washer 13/32 x 1 x 11 Ga.
CONTENTS OF HARDWARE PACK
(1) Pivot Bolt
3/8-16 UNC Grade 5
Extra Shear Pins & Clips
LEFT
overhead_views_1
OPERATOR’S POSITION
RIGHT
FRONT
