EN
OperatiOn
1800_EN-Einsatz_2723
- 31 -
Control unit Single rotor control unit
Pre-select the rotor to be operated using the control unit
Left - left rotor
Centre - both rotors
Right - right rotor
Terminal position on the parked machine:
Using a T-screw, the terminal can be attached to the parked
machine on the shaft (4) underneath the cable tray.
Swivelling from working to headland
position
075-09-10
DAN
DANgER
life-threatening danger through machine tipping over.
•
Carry out the change from working position
to transport position, and vice versa, only on
level, firm ground!
DAN
DANgER
life-threatening danger exists through moving parts
when changing from transport to working position.
•
Make sure that the swivel range is clear and
that no-one is standing in the danger area.
•
Switch on the PTO shaft drive only after all
guards have been moved to the working
position.
•
Do not enter the danger zone yourself.
Swivelling from working to headland position is effected
via a single-action hydraulic connection (floating position
required).
- The cardan shaft drive does not have to be switched
off.
TIP
For clean ground hugging:
1. Bring the device into working position
2. Set the control unit of the tractor to floating position.
mechanical working width adjustment
TOP 762 C
TOP 762 C classic
mechanical: (with swath apron)
working width adjustable between
6.9m and 7.4m.
TOP 702C
mechanical: (with swath apron)
working width adjustable between
6.45m and 6.85m.
TIP
The TOP 612 C is not equipped with a working width
adjustment.
mechanical adjustment of working width on arm:
1. Release safety latch (1)
2. Pull bolt (2) out of the slot (4).
3. Adjust the spindle (3).
4. Fix the bolt in the slot.
The bolt must be easy to insert in the slot even after
spindle adjustment.
5. Lock spindle with safety latch.
2
1
3
4
Hydraulic working width adjustment (on
request)
TOP 762 C
TOP 762 C
classic
Working width is infinitely adjustable
