29
Bogie beam
Checking the bogie beam bearing
•
Check the clearance of the bogie beam bearing before lubrication.
•
Extend the cultivator on a level surface.
•
Lower the cultivator on its tines so that the wheels lift off the ground.
•
Push the rear wheel so that the front wheel is off the ground. Move the bogie
sideways. If you feel play in the bogie beam, tighten the bogie beam bearing
according to the instructions
.
Tightening the bogie beam bearing
•
Extend the cultivator on a level surface.
•
Lift the cultivator up on its wheels.
•
Place secure jack stands under the frame beams at the rear end of
the cultivator. Use 2 jack stands per section.
•
Lower the cultivator so that it is supported by the jack stands and tow hook.
•
Lift the wheels fully up.
•
Open the lock washer tab and open the outer nut.
•
Remove the outer nut and lock washer.
•
Tighten the inner axial nut to
40 Nm
. Hit the bogie beam against the limiter
2–3 times. Tighten the axial nut again to
40 Nm
. Repeat this procedure until
the axial nut cannot be tightened with a tightening torque of
40 Nm
.
•
Install the lock washer and tighten the outer nut to
40 Nm
.
•
Turn the outer nut in the closing direction to align a lock washer tab to
the nearest locking groove.
•
Lock the nut by turning the tab into the groove in the outer axial nut.
•
Press petroleum jelly into the hub until some lubricant comes out of the hub.
Summary of Contents for MAGNUM PLUS 1000
