G-2108/G-3106 User’s Manual Chapter 2: Setup and Use
14
2.2.4
Loading the Media
The G-2108/G-3106 printer can be operated under four different modes: Standard Mode, Tear-off
Mode, Cutter Mode, and Peeler Mode.
•
In Standard Mode, the printer stops and goes into standby as soon as the print job is complete.
•
In Tear-off Mode, after the print job is finished, the printer will feed the label until the edge of
it aligns with the edge of the Tear-off Bar allowing easy tear off for the user.
•
In Cutter Mode, the printer stops and cuts the printed label(s) (Only available on models with
cutter installed).
•
In Peeler Mode, printer stops and waits for the printed and peeled off label to be taken away
before resuming the print job (Only available on models with peeler installed).
Standard Mode
To load media into the G-2108/G-3106 printer while under Standard Mode, follow the steps below:
1.
Load a roll of media (labels facing up) on the Media Spindle, then slide the two Media Roll
Guides, with smooth sides facing toward the media, onto the Media Spindle from each end until
both Media Roll Guides touch the media. When placing a roll of media with a 3″ ID core, please
slide the two Core Adapters onto the Media Spindle first, as shown in Figure 2-11.
Figure 2-11 Place Media Roll on Media Spindle
2.
Place the entire unit into the media compartment in the printer.
3.
Position the media roll in the middle of the Spindle, using the ruler on the Media Spindle for
alignment.
4.
Thread the media under the Media Guide Rod and Transmissive Media Sensor, as shown in
Figure 2-12.
Media Roll
Media Roll Adaptors
Media Spindle
Media Roll Guide
Media Roll
Module correctly
fitted with Spindle
and Guides
